#Wings 3d units windows

Now Move the inset roof face up in the Y direction for 0.50 units (Figure 12.d). Then select the top face and Inset by 75% (Figure 12.c). Select the two left over vertices on the roof lines and Collapse them (Figure 12.b). Select the two edges that go from the side sections to the main roof and Dissolve them (Figure 12.a). The results of the Intrude are shown in (f). Select all the faces that will be used for the Intrude command in (e) and Intrude. The three edges on the front face were then Moved down in Y (b) to resize the door face. The thickness of the walls is determined by how much you move the mouse while Intruding. Figure 11.f shows the results of the Intrude operation. Now Intrude to hollow out the shell of the dog house. Select the door, windows, and the three floor faces as shown in 11.e. You should have something similar to that shown in Figure 11.c.

#Wings 3d units windows

Then select the two windows and Scale them down in Y by 0.50 units to square them up as well. Select the front faces of the side sections and Inset some windows as seen in Figure 11.a Move the front three edges that run horizontally across the front of the main cube down in Y by 0.50 to square up the door as shown in 11.b. You should have something similar to that shown in Figure 10.f.

Select the two long edges on the front face and Cut by 3. Then Select the two vertices on the front face and Connect them as shown in Figure 10.e. You should have something similar to that shown in Figure 10.d. Select the two large faces, one on each side, and Extrude Normal by 1.0. In (f) the new edge and the bottom edge were Cut by 3 and the resulting vertices then Connected. The vertices on the front face have been Connected in (e). Do both sides of the model at the same time to ensure symmetry. The new edge and the two side edges were then Connected in (b). The top and bottom edges have been Connected in (a). You should have something similar to that shown in Figure 10.c.įigure 10. Simply stop dragging when the value reads 0.50 and left click the mouse. You can see the units change in the Status Bar at the bottom of the Wings window, below the Icon Bar. Then Move the vertical mid-edges forward in the Z direction on both sides by 0.50 units. Move the horizontal mid-edges up in the Y direction on both sides by 0.50 units. You should have something similar to that shown in Figure Hit the Space Bar to deselect the new edge. Select the three vertical edges on one of the sides. You should have something similar to that shown in Figure 10.a. Repeat the operation on the opposite side of the cube. Then Connect them (remember to right click to bring up the Edge menu). Select the lower and upper edge on one of the sides. Don't bother to save the tooth, unless you really want it.

If you still have your finger exercise up, do a File New.